THAT'S short and small?!6 days since flipping to 12/12. Some pistils starting to form at bud sites. I think I might stick to photos from here on out. I can’t seem to get my autos to grow as big. I know they don’t veg as long but the last 2 I’ve grown have been short and small.
This one's about to Godzilla the town!6 days since flipping to 12/12. Some pistils starting to form at bud sites. I think I might stick to photos from here on out. I can’t seem to get my autos to grow as big. I know they don’t veg as long but the last 2 I’ve grown have been short and small.
Oh no this is my photo lolTHAT'S short and small?!
I only top water a little bit until I can see its feeding from the reservoir then I no longer top feed but I don't use your nutrients i use MegaCrop.Good evening all you SIP heads........
I plan on making a couple of diy sip containers probably 3 or 5 gallon for the clones. I have read quite a bit thru this thread and watched a few Youtubers and now feel as though I have a plan to build a couple of these gizmos.
I hope I'm making sense I just tried a small nug off the lsd plant thats nearing the finish line and I'm a little baked
Here's my question.......I use @GeoFlora Nutrients, so how do I top water in the Geoflora Nutrients? Anybody have a simple solution? Id love to hear any feedback from anyone using top dress nutes.
Absorber...That is a well thought out well engineered design. WowI only top water a little bit until I can see its feeding from the reservoir then I no longer top feed but I don't use your nutrients i use MegaCrop.
Here's my SIP design
I used two 20ltr buckets per SIP a 90mm to 100mm reducing bush, I cut the 100mm part of bush leaving a large shoulder to support the floor of the pot above the reservoir. The bush fits onto a bit of 90mm stormwater pipe that I either drill or slot with 5 inch grinder with skinny cutting discs, the floor of the pot is made from the bottom of the second bucket I cut the bucket in half 14cm up flip the bottom upside down cut hole in the centre for bush to poke through and drill heap of holes in the base.
The top part of the bucket i fit into the top of the SIP for extra dirt holding capacity.
SIP will hold about 6-7 litres roughly.
Good luck with your construction
I do- they won't always stop your plant from flowering, but they can slow the process way down.
They probably did that to contain all of the medium personally I think you'd have to chop a hole in the bottom middle to get the foot to wick properly.
Best practice with Geoflora nutes is to feed every two weeks as a top dressing as they suggest and to water in that feeding from the top. Between feedings simply pour your water down the fill tube.
Will do. I’m going to find some black mesh
Thanks Azimuth!
Enjoy your puff or two & the rest of the thread @Ramblinrose1965 peace & take care dude
I keep it tight. No light leaks.
Emilya Green grew her SIP's with Geoflora top watered I believe. Check out one of her journals.Good evening all you SIP heads........
I plan on making a couple of diy sip containers probably 3 or 5 gallon for the clones. I have read quite a bit thru this thread and watched a few Youtubers and now feel as though I have a plan to build a couple of these gizmos.
I hope I'm making sense I just tried a small nug off the lsd plant thats nearing the finish line and I'm a little baked
Here's my question.......I use @GeoFlora Nutrients, so how do I top water in the Geoflora Nutrients? Anybody have a simple solution? Id love to hear any feedback from anyone using top dress nutes.
Usually 2-3 weeks depending on the strain. If it takes longer to start flowering, expect a longer time before harvest as well.
