Finished my vortex brewer. I think I'll still make some tweaks to it eventually. The spout is pretty low so I'll fix that soon. Aside from that it works great!
I ordered a 3gal plastic carboy off Amazon.
And a 1" uniseal. This is checking for placement.
Drill with home saw 1 3/4" bit.
I drilled out using a 3" hole saw the bottom so I can add water and amendments.
Push the uniseal in from the inside and put in a 3/4" 45° elbow.
Got a rubber coupling to fit the bottle neck. Couldn't find one that fit the pvc but found a piece that worked well.
Found a rubber ring in the toilet section. Used that to cushion the bottle.
Here is the bottom
We go from the jug down to a Tee. The tee goes out to a spout. I read that 1' is recommend for a better vortex but I will eventually shorten it
The other side runs to another tee and goes up into the jug. The last part is a 90° elbow that is threaded. I picked up a nipple that accepts airline
I'm using the eco1 commercial pump. It's only strong enough for 1" pvc if I recall correctly. I used 1 1/2" and it didnt work so now I'm using 3/4"
Here it is on the table. Added rope to keep it more stable the vortex is better when it's even.
Here is my vortex!
that would be the way to go ? 
