Hmmm… I have a problem, and a solution.
I tested the heat in the tent from the MH/HPS lights on, just a bit on the lowest setting, which is 50%, or 300w. I kept thinking it said 250/400/600. But once again, me old brain thunked wrong. It is 50%, 75%, or 100%. Regardless, I added an in-line fan and some ducting to pull fresh air in and blow the hot air out the other side and I tested the tent. It very quickly got into the low 80’s. That’s too hot and I can only imagine cranking it up would cook the girls in this little 2’x4’x5’ tent. And it really left me bad choices with trying to fit a carb scrubber in there too.
I bet some of you knew this was coming!
I had read a lot of info, but I loved
@7Dust2 ‘s
Growing 2x2 With ViparSpectra XS1500 Pro
Journal testing these lights and I really liked them. I have old LED lights from 2012, but figure they are pretty ancient, so I did buy two of the ViparSpectra XS1500 Pro lights. They will work so much better in this small tent and my carb scrubber will fit so much easier at the top. Thank you
@7Dust2
I’d put a link in but I have to figure out how again!
I will try the MH/HPS in the bigger tent (5’x5’x6’), and we’ll just take it one step at a time. Maybe it will work in there. Winter is coming and that would sure help a lot! No matter what, I’m keeping my hps lights in my thoughts. I used them (and 1000s) in the entire open room where I’m now using much smaller closed in areas. I’ll roll with it. My title of this journal is going amiss, but I may still have a use for them before I’m finished.
In the meantime, feel free to give me suggestions on different lights in a 5’x5’x6’ grow tent in case I have to make hard choices there too.
That’s it!
Warm Granny Hugs