Unknown Strain From Seed - First Time Grow

I feel like my canopy could be a little more even but not bad.
Shes just starting to go crazy lol
420-magazine-mobile2051732743.jpg

Sent from my 5054N using 420 Magazine Mobile App
 
Islandgrow said:
Tie those down as well get it all even now before flower. All the lower nodes should branch and come up as tops .

"carpe diem"
Click to expand...
Thx island I already did....I started early and been keeping up like every two days.

Sent from my 5054N using 420 Magazine Mobile App
 
cannoisseuras said:
Thanks ditch I trimmed a few suckers and she seemed to love it.

Hey when you place a cutting into its medium is it normal for it to wilt and droop before it takes

Sent from my 5054N using 420 Magazine Mobile App
Click to expand...
Did you cut at a 45 degree angle as well as take all the leaves off except for the top set and also even cut those tips also the cuddling focuses on rooting instead of growing

Sent from my Robin using 420
 
I also use the humidity Dome and make sure my humidity is around 80% and open my door up twice a day spray the top of the plants with just plain pH water and make sure that it has enough heat and humidity for roots to develop

Sent from my Robin using 420
 
This is my cloning tray with dome on a heat mat, i lift dome twice a day spray with ph water and then lets sit on a heat mat, after 4 days i open vents on dome a lil and each day after a lil more til 8 days or 9 then i take it off completely. I like rockwool for my medium to start clones. My success rate is 90% with this method. You just need heat and humidity and light. 18/6;is the best light schedule bc dark times promote root growth.
c74c9e0b13663ad8c6dfee879b21398c.jpg
e9b8cb166f5d406366ec549f0bda55b1.jpg
0fff48e86c2d83328d0b5b0883fcf3c1.jpg
29b6903a1b38cda2ed46ba18ce22cfd0.jpg
da5ddb5c9e14c5f85834ae345ac2a781.jpg
 
ken042480 said:
Did you cut at a 45 degree angle as well as take all the leaves off except for the top set and also even cut those tips also the cuddling focuses on rooting instead of growing

Sent from my Robin using 420
Click to expand...
Yup I did all that stuck in a bucket with a shielded cfl above it...plus I used that gel from inside an aloe leaf

Sent from my 5054N using 420 Magazine Mobile App
 
Now make sure they are cut with a sharp razor and also cut at 45 degree angle i even make a small slit in the bottom to give more room for rooting hormone to get taken in by cuttling.
 
cannoisseuras said:
The cutting itself is not planted in a bucket but its in a solo cup sitting in a bucket

Sent from my 5054N using 420 Magazine Mobile App
Click to expand...
Just make sure your humidity is up and make the cuttling look for water so dont keep your medium wet. Only spray the leaves. And then patience brother it can root in 5 days or 14 it just depends on environmental things and strain.
 
cannoisseuras said:
I sliced it to ken...lol was just wondering if its normal to droop until the roots start

Sent from my 5054N using 420 Magazine Mobile App
Click to expand...
Best way to me is cut and put in a cup of water then to moist soil with dome. Should not wilt at all. if it wilts probably not gonna take. I took some clones off a wilting plant and they perked up in a cup of water. Root aphids killing that plant

"carpe diem"
 
Mine will wilt a lil bit and yellow a lil bit. But as soon as roots develop then i transfer to whatever my plans are and they spring back up and yellowing goes away.
 
Islandgrow said:
Best way to me is cut and put in a cup of water then to moist soil with dome. Should not wilt at all. if it wilts probably not gonna take. I took some clones off a wilting plant and they perked up in a cup of water. Root aphids killing that plant

"carpe diem"
Click to expand...

Likewise, my go straight from cutting to water and I leave them there for a day or so and never had issues with wilting.
 
Back
Top Bottom