InTheShed Grows Inside & Out: Jump In Any Time

Tuesday update!

A few little quickies today. First is that Sour G seems to be recovering from the light stress while hanging out under the 23w CFL all night. Do you agree?


Next up is a formal introduction to Bedroom Cookies Pheno 2, on day 43 (thanks @Archiweedies!). I fed it half strength nutes yesterday but I think it needs less N so I'll back that down next watering:

I mentioned a while back that I had given away all my Sour G clones except the one in the cloninator. Well...that one went into soil with loads of roots but a mushy stem, and it doesn't look like it's going to make it. So I'm going direct into soil with these since I want to shut down the cloninator as soon as the PC top gets enough roots to get planted (I want to use the bike shed to flip if I can...weather permitting). I also stuck in some cuttings from the PC and the FIMTFIM top from Candida w'tap:

These have been in water for one or two weeks but that hasn't been an issue before. They were dipped in Dip'n Grow at 15 dilution for about 5 seconds each before going into the ProMix HP that was wet from the rain, and then soaked with distilled water before being capped.

And last, here is the spooky man in the sweat jacket. I tossed it on the breakfast bar to repair the grommet by the hood string and this was looking back at me o_O:

Yea, though I walk through the valley of the shadow of death, I will fear no evil: for I had 5-minute 2-part epoxy and a repair job to do...completed successfully!

It's cool and bright this week so even though the highs are in the mid-60s, the radiant heat from the sun should be warming the roots. I hope your week is going well!
:peace:
 
I don't know that I would ever do anything with a 30% success rate unless it was speed dating! [In case my wife divorces me I'm leaving that option open given my age ;).] In the time I waited to see if it was successful I could have been doing a lot of other training that might have been just as productive in the end. Who knows?

Good luck with it this time! I guess we'll know in a week or so :thumb:.
Couldn’t agree more, lol and why nobody does it I’m guessing. This is a plant I would have otherwise culled, so it’s getting the experimentation treatment. This thing will look like an Edward Scissorhands lawn sculpture by the time I’m done with it.
 
Tuesday update!

A few little quickies today. First is that Sour G seems to be recovering from the light stress while hanging out under the 23w CFL all night. Do you agree?


Next up is a formal introduction to Bedroom Cookies Pheno 2, on day 43 (thanks @Archiweedies!). I fed it half strength nutes yesterday but I think it needs less N so I'll back that down next watering:

I mentioned a while back that I had given away all my Sour G clones except the one in the cloninator. Well...that one went into soil with loads of roots but a mushy stem, and it doesn't look like it's going to make it. So I'm going direct into soil with these since I want to shut down the cloninator as soon as the PC top gets enough roots to get planted (I want to use the bike shed to flip if I can...weather permitting). I also stuck in some cuttings from the PC and the FIMTFIM top from Candida w'tap:

These have been in water for one or two weeks but that hasn't been an issue before. They were dipped in Dip'n Grow at 15 dilution for about 5 seconds each before going into the ProMix HP that was wet from the rain, and then soaked with distilled water before being capped.

And last, here is the spooky man in the sweat jacket. I tossed it on the breakfast bar to repair the grommet by the hood string and this was looking back at me o_O:

Yea, though I walk through the valley of the shadow of death, I will fear no evil: for I had 5-minute 2-part epoxy and a repair job to do...completed successfully!

It's cool and bright this week so even though the highs are in the mid-60s, the radiant heat from the sun should be warming the roots. I hope your week is going well!
:peace:

Sour g looks to be turning around! Some nice green colour coming back well done I hope she turns right around she’s a gorgeous plant!

Bedroom cookies yum! That’s sweet you and @Archiweedies can trade!
 
Oh I wanted to get this into a post by itself so I can bookmark it if I need to refer back to it. Sorry for the repeat:

Final weight of Blue Treacle Auto 2, harvested on day 100:
Smokeable bud: 152 grams or 5.4 ounces
Botrytis bud dried: 19 grams or .7 ounces
Total of 6 ounces dried. Not bad!

For the record, I include the weight of the botrytis bud in my total weight because it will go into topical oil, and if I didn't use it I would have to use that much more smokeable bud. And I never bother weighing trim because it just goes in a big bag of frozen trim!

You got 6 ounces off of one auto? o_O . WOW!!!!!

If you don't mind, here's what I did today. My first coco/perlite grow and with an Auto.

I'm following a feed chart from FN for Autos in Coir. It says nothing about PPM or TDS, but I will read again to be sure.

I'm running roughly a 51/50 mix in a 5 gallon plastic cup. Seed in glass water 24 hrs, paper towel, I just put the tapper into a root cube, the spongy ones. I soaked the cube first with water and calmag (1gln x 1 tsp). I put the cube in the coir and wet the surrounding area with the same solution. I covered the cube with a thin layer of the mix.

Wondering how wet to keep coir early on. Is it still drain to waste, water till runoff?
 
I'd put that question in a coco thread Agemon though I'm sure most of the folks passing through here are in coco. Maybe Derby or Newty since I saw you ask in MadDab's thread.

In terms of PPM, if you're just following a chart you have to assume that the chart's creator has done the PPM work for you.

Couldn’t agree more, lol and why nobody does it I’m guessing. This is a plant I would have otherwise culled, so it’s getting the experimentation treatment. This thing will look like an Edward Scissorhands lawn sculpture by the time I’m done with it.
See if you can get a real topiary look to it...an elephant would be good!
Sour g looks to be turning around! Some nice green colour coming back well done I hope she turns right around she’s a gorgeous plant!
Bedroom cookies yum! That’s sweet you and @Archiweedies can trade!
Thanks Dutch! I'm hoping that the greening continues so I can flip around Feb 1st, depending on how big I want PC to be.
:thumb: on the SG recovery
:thumb:
:popcorn:
Thanks Amy! And you know you will hear about it when it happens :cool:.
 
Sour G definitely looks better today. Those dam leds. I'm on the spot with my plants now regarding cal/mag and stress of that kind I think :goodluck:.....

Bedroom Cookie looks awesome! Quite big in that cup. Is this what u use in your cookies? ;)

this was looking back at me

Another cookie too much... Write note to wife about fixing a lock on the cookie cabinet.
 
You can absolutely make fan leaf oil. It's just not nearly as strong as oil made from buds or trim.

You start by decarbing the leaves first like you do with buds. Then you slow cook with your oil (I use EVOO but others use coconut or avocado oil) at around 160-180º F for 8 hours in whatever you have on hand. Stir about every 23-30 minutes. You can use a turkey roaster or a crock pot if you have a lot, or just a regular sized pot if you have a smaller collection of fans. The less oil you use the stronger it gets, but you still have to cover the leaves.

You're not cooking the oil off (it should never boil), just infusing the oil with the goodness of the leaves. When you're done, strain the oil with cheesecloth and you're done!

Let me know if you have any other questions. We have a lot of oil makers here!
:high-five:
 
Tuesday update!

A few little quickies today. First is that Sour G seems to be recovering from the light stress while hanging out under the 23w CFL all night. Do you agree?


Next up is a formal introduction to Bedroom Cookies Pheno 2, on day 43 (thanks @Archiweedies!). I fed it half strength nutes yesterday but I think it needs less N so I'll back that down next watering:

I mentioned a while back that I had given away all my Sour G clones except the one in the cloninator. Well...that one went into soil with loads of roots but a mushy stem, and it doesn't look like it's going to make it. So I'm going direct into soil with these since I want to shut down the cloninator as soon as the PC top gets enough roots to get planted (I want to use the bike shed to flip if I can...weather permitting). I also stuck in some cuttings from the PC and the FIMTFIM top from Candida w'tap:

These have been in water for one or two weeks but that hasn't been an issue before. They were dipped in Dip'n Grow at 15 dilution for about 5 seconds each before going into the ProMix HP that was wet from the rain, and then soaked with distilled water before being capped.

And last, here is the spooky man in the sweat jacket. I tossed it on the breakfast bar to repair the grommet by the hood string and this was looking back at me o_O:

Yea, though I walk through the valley of the shadow of death, I will fear no evil: for I had 5-minute 2-part epoxy and a repair job to do...completed successfully!

It's cool and bright this week so even though the highs are in the mid-60s, the radiant heat from the sun should be warming the roots. I hope your week is going well!
:peace:
She is looking better to me good job..
yeah the jacket is a lil weird in creepy lol..
 
Your plants do look amazing!!!
Thanks Mushie! How they look varies with all sorts of things with my crazy growing method...you just happened to drop in during a pretty good stretch. It will be even better when my Sour G is a loverly shade of green again!

I have spent the last 20 months trying to sort out how to get the best out of my indoor/outdoor perpetual system, and I'm trying to get a little better at it with every plant.
 
Back
Top Bottom