- Thread starter
- #681
Green Utopia
New Member
Light Rails
On a side note. One thing that has proved to be a little tricky is routing the wires for the lights and motors on the light rails. A 3' run is no biggee, but the 6' runs require some significant planning to accommodate the moving wires.
Also, and perhaps the trickiest aspect of all for me so far - running the ducting. Not sure if I'll be able to pull it off in this size room. Basically, think of 6' of ducting getting stretched out to six feet at the far end of the track, but then retracting to a foot at the near end. I think bungees for support is gonna be the answer, but if anyone has any experience with this in a small space, and without using a whole nother trolly just to support the ducting - I definitely am open to suggestions.
On a side note. One thing that has proved to be a little tricky is routing the wires for the lights and motors on the light rails. A 3' run is no biggee, but the 6' runs require some significant planning to accommodate the moving wires.
Also, and perhaps the trickiest aspect of all for me so far - running the ducting. Not sure if I'll be able to pull it off in this size room. Basically, think of 6' of ducting getting stretched out to six feet at the far end of the track, but then retracting to a foot at the near end. I think bungees for support is gonna be the answer, but if anyone has any experience with this in a small space, and without using a whole nother trolly just to support the ducting - I definitely am open to suggestions.