Topping off ur nutes

[jungle]

I was having serious problems with my 2 x Active Air 8-nozzle pumps running so hot it would melt the rubber feet and over the course of a few hours skate so far the hose would disconnect. I had to solve it by literally placing a decent size fan on high blowing right at it. it dropped my res temps by around 5 degrees. this way the pumps weren't sitting in their own "hot air" the cases were putting off and fresh cooler air was circulating.

Hi toasted,
Yea I have the same problem with the air pump running hot and the rubber hose fell off, I end up cut the hose shorter and add silicon on both end and cut a 1/2" hard rubber hose cover the outside with lock tight + tight the nozzle too the pumps with the rubber string , I add a nother hose from the pump intake out side so it have cool air into the pump,
I will use your idea and add an extral fan to cool them down too.
Thank you