^^Ok, keep us posted on how they're doing and what you think about ST. I don't have much experience with cloning but my seedlings get only water+Superthrive for the first 2-3 weeks.
I usually start with a few drops/gallon and work my way up to around 1/4tsp(1ml)- depending on the plant. But my guess is your clones will be fine.
Thank you.....
I actually have a Q for you guys then...LOL....
I started my clones in the cloner as I stated above, I PHed the solution to 5.5 and let her go... so last night would be the end of the second (or 3rd???, either way...) day I had them in the cloner and a last second decision made me shut everything down and check the PH, it was running 6.8-7.0.... needless to say I freaked out and changed the solution and set it back up with some fresh water with a drop or 2 of superthrive per gallon along with a few ML per gal of hygrozyme and I dropped the PH back down to 5.5-.6. That was at 11:30pm last night, this morning @ 9 or so its back up in the mid 6's. I dropped it back down and will be checking it again in a bit but what would cause that? Everything was sanitized fairly well, I used only RO water.
light sch 18/6 (cant run 24/0 as I have mothers in the same room and dont have the option of separating them at this point in time and dont want to switch them back to 24/0, they've dealt with enough stress at this point)
No direct light yet, I have 2 23w CFL's way up high off to the side of them and one of my T8 lights are throwing some ambient light on them.
Room temps - 75
res temps 76-77 maintained with an aquarium heater
humidity 80+% (I know I dont need a dome on it but I have been using one because its helping keep temps and humidity up on the cuttings).
Any thoughts or ideas other than I probably shoulda posted this somewhere else but why start another thread..