Purple Queens...
PQ 1:
9am
9pm
PQ 2:
9am
9pm
In the group photo you can see the tree skirts I made for them out of old tshirts...
I've given each plant a single shot of 1/4 strength Dyna-Gro GROW (7-9-5) from a spray bottle at 9am and 9pm. I also have my automated feed system pumping PH'd RO for 15 minutes every 3 hours.
Each bucket has a single feed line w/ a 2 GPH drip emitter so that's about 1/2 gallon every 3 hours. The new buckets are a bit bigger than the old ones and hold about a gallon of solution in the bottom when the buckets are empty. I'm not sure how much less they hold when filled with perlite.
I have a DIY 6" intake fan pushing air from the cabin through a carbon filter into the tent. Input CFM is unknown. Once my 6" to 4" splitter comes in I'll use my Neverest RV-B 6" 412 CFM fan to push air into both tents, but until then it's too much for the single tent and blows it up like a balloon.
I have a Vivohome 4" 195 CFM exhaust fan in the attic that goes to a carbon filter and then a 4" to 4" splitter. 1 output just vents in the attic and the other is routed back into the cabin with a blast gate. I'm hoping when the air gets cold and dry this winter it will help me keep the temperature and humidity up.
Inside the tent I have 2 6" clip on fans for circulating air and I'm awaiting arrival of an oscillating vortex fan. There is also a cold mist humidifier in the tent. I have an automated system that reads temp / humidity and calculates VPD. It uses the VPD calculation to control the exhaust fan and humidifier. The intake fan runs 24/7 to keep fresh air in the tent.
For lighting I have 4 Giixer 1000W Plus Full Spectrum High PAR Value Simulated Sunlight LED Grow Lights. I'm currently only using 2 of them and the plants are getting between 17-26K lumen.
Once they go into full veg I'll post strain details and start making more regular reports. I'm planning to update once weekly at a minimum so we'll see how that goes