SgtKiLLx's 2nd CoCo Grow & Companion

[SgtKiLLx]

@Emilya . Finished product. Didn't turn out too bad.

 

[SgtKiLLx]

@Emilya. Your 13hr print has begun.
(witha few fails already)

 

[SgtKiLLx]

gonna try to orient them in a diff way. seen an issue with lying them down.

 

[SgtKiLLx]

so far so good. first few layers no problems. I think we are a go.
stats: 13hrs 35min
206g
69m of material used
(Failed first)
Attempt #4. Looks a bit more promising. Can't waste too much material or I'll be out before this prints done.

 

[SgtKiLLx]

@Emilya .

 

[SgtKiLLx]

6.5 hours in.

 

[SgtKiLLx]

@Emilya .

 

[SgtKiLLx]

I incorporated very small clip balls on both sides. Guess what. Has a nice snap to it . Voila. Messed up with adjusting tension. Last few layers were messed up. No biggy. Prints done in my opinion. @Emilya .

 

[Emilya Green]

Very cool Sarge, and I think those are going to work just fine! I will get them installed as soon as they arrive and I think this is going to neatly solve the problems caused by the bowing in of my tent. I will get pictures up as soon as I have achieved installation!

 

[SgtKiLLx]

Yee. Got some much needed upgrades for my machine. Can start doin serious printing now.

 

[SgtKiLLx]

@Emilya , thank you for choosing SgtKiLLx's 3D Printing service. Please rate your experience on a scale of 1-10



The ripples/waves that go up the height of the pieces was due to messing up the cooling fans , putting in 2 fans to 1 extruder(which I have) messed up the slicer and confused it. Have since fixed this issue, however it shouldnt effect the use of them.

 

[SgtKiLLx]

@Emilya, have ya got those installed yet?

 

[Emilya Green]

@Emilya, have ya got those installed yet?

No, we got an ice storm, so didn't get out to get the PVC today.

 

[SgtKiLLx]

No, we got an ice storm, so didn't get out to get the PVC today.

Oh damn. I'm jus eager to see em setup.

 

[SgtKiLLx]

Sharkz clip.

SHARKZ... Fun Multipurpose Clips / Holders / Pegs with moving jaws that bite! found on #Thingiverse SHARKZ... Fun Multipurpose Clips / Holders / Pegs with moving jaws that bite! by muzz64

 

[Emilya Green]

you get it all fixed?

 

[SgtKiLLx]

you get it all fixed?

I put it all back together. Still using the shitty Y extrusion. It's not too bad. Doable. Tolerable. For now. Til I get the new piece.

Amazon.ca

 

[SgtKiLLx]

Gotta tray for Vector. He kept falling off the table and it's a good 2ft drop. 250$ robo and drops don't mix.