True does that mean smoke will be harsher ?
Monster Cloning & Seeds, LEDs, Promix & Soil
- Thread starter Lowded118
- Start date
-
- Tags
- ×lowded118
Shouldn't, I think that's going to be more drying and curing really.
- Thread starter
- #1,003
Ok we’re going to dial back on ppm about half!
There ya go
Not half! Those are veg numbers 
. 600 and see how they respond.
. 600 and see how they respond.- Thread starter
- #1,006
ok one more thing, the @TheMadDabber said 200ppm camg in flower, do I continue or start dropping camg too after week 5?
- Thread starter
- #1,007
My last was 1200ppm lolNot half! Those are veg numbers
Oh, then half is perfect! I don't do calmag in ppm, I do it in ml/gallon. I stick around 3ml.
3 ml per gallon is what I normally add
- Thread starter
- #1,010
Wow thats double lol. Got it 3ml per g it is! Holy f that might be all I use.
1.2ml/g now is where I’m at. There’s some learning going on here now!
Same for veg? I’ll be mixing veg nutz soon and flower later tonight.
So when you suggest 600, then add 3ml calmag? Or 600ppm w calmag
1.2ml/g now is where I’m at. There’s some learning going on here now!
Same for veg? I’ll be mixing veg nutz soon and flower later tonight.
So when you suggest 600, then add 3ml calmag? Or 600ppm w calmag
philthegeek
Well-Known Member
"I have flushed so many times I think I emptied the airspace. yea iti maybe I need one more transplant closer to flower to help the airspace? "
Rather than shocking the plants with a full on transplant, maybe try poking lots of narrow holes in the soil from the top down?? Have seen the grounds guys at work doing that with the lawns. They have a spiky roller thing they drive over the lawn and it pokes holes a few inches deep every where.
Rather than shocking the plants with a full on transplant, maybe try poking lots of narrow holes in the soil from the top down?? Have seen the grounds guys at work doing that with the lawns. They have a spiky roller thing they drive over the lawn and it pokes holes a few inches deep every where.
I usually add calmag first
- Thread starter
- #1,013
Lol I was doing that when I had yellowys I had a #6 electrical wire I’d poke into. I haven’t performed that in a while. Good one !!!
- Thread starter
- #1,014
Gotcha so 600ppm or whatever number I pick includes camg.
Derbybud
Well-Known Member
Correct
- Thread starter
- #1,016
Thanks boys so 15ml/5g start 80ppm end 360ppm. So 400ppm AN BM and terpy!
And then veg will get same 3ml/g with only 100-200 ppm of AN GBM
And then veg will get same 3ml/g with only 100-200 ppm of AN GBM
Don't forget to back out the ppm of your water. That's not included in the final number.
- Thread starter
- #1,018
Ok good news. I was not doing that. But I also previously had tap water Of 270ppm. Now we’re RO and at 80, which I suspect is more equipments reading off. Only due to ph moving so fast a drop to 5g = 1point ph change. Ok this again will be totally different to how I’ve been operating in here!
I do the same
Derbybud
Well-Known Member
Unless i'm using silica blast then I add that first and let sit for 15-20 min. Then cal mag