- Thread starter
- #41
Dantes Monkey
New Member
Initial temperature tests are not looking good. Tent 3 hit 90 degrees in about an hour. I'm probably going to have to open up a few more intakes to double the capacity of the passive airflow. I did tape the ducting into place to create additional bends for light proofing. I was still getting a little light bleeding in from the adjacent tents. I then flipped the mylar floor of the tent upside down so the black side is facing up and that took care of about 99% of the light bleed. I think the rest will be taken care of by a few cut to fit air filters over the ducts. Right now my temps are my biggest concern. Firing up all three panels does generate a lot of heat.
On a positive note, I think I'll be able to run this entire rig on a single 15 amp circuit. I was concerned that I would have to run an additional line from the breaker box, but I think we'll be ok.
-Monkey
On a positive note, I think I'll be able to run this entire rig on a single 15 amp circuit. I was concerned that I would have to run an additional line from the breaker box, but I think we'll be ok.
-Monkey