MarsHydro Sponsors Giveaway Appreciation Grow Room 2 RDWC

[Absorber]

Oooh I forgot to update. All three cheese clones finally rooted so will grow two of them after April. I have noticed they really do not like the cold so will make sure my room is well heated.

This clone was planted straight In Coco and left. Id be confident to say it rooted within two weeks but still took a week or so to show roots out of the Coco.

Now I think I showed this one already but I have two that rooted in root riot plugs.

And life goes on

 

[Greenvein]

Mars Hydro Giveaway grow
New light FC3000
Cheese Soulfire clones
Prepping
​

Good morning 420! It's almost been a week since I ripped out my cheddar and replaced it with my soulfire clones. They have pretty much been sitting unhappy & neglected but I found time yesterday to clean my room up.. turns out their was another factor my cheese struggled and that was the cold. My 3x3 is right Infront of a door where cold air is blasting through.

Not sure if I posted this pic already but this is how my clones was sleeping rough for the week after up pot.

The tube heater wasn't plugged in everything was just dumped in.

Saturday, I got some benches mad up with spare wood. Then dug out that bucket I was going to use as a resovoir in the beginning of this journal. I previously blocked off the holes so was perfect for DWC. This was filled with nutes and bleach ready for transplant.
Sunday, I pulled as much out of my tent as I could and got my auto up potted so I could fit my benches in.

One side has thicker ply for drainage but both are slightly tilted to toe right. Both benches have 100w tube heaters underneath to hopefully add some heat to the tent. I still need to clean up my wires and get my resovoir prepped but it's in!

My clones weren't too happy. Last night when I checked on them this is how they looked

I think they was looking a bit better this morning but I could only poke my phone though the zipper as my 4x4 was still sleeping.

That's all I got for now but were I full force in a couple of days. Back to the grind for me

 

[Absorber]

Mars Hydro Giveaway grow
New light FC3000
Cheese Soulfire clones
Prepping
​

Good morning 420! It's almost been a week since I ripped out my cheddar and replaced it with my soulfire clones. They have pretty much been sitting unhappy & neglected but I found time yesterday to clean my room up.. turns out their was another factor my cheese struggled and that was the cold. My 3x3 is right Infront of a door where cold air is blasting through.

Not sure if I posted this pic already but this is how my clones was sleeping rough for the week after up pot.

The tube heater wasn't plugged in everything was just dumped in.

Saturday, I got some benches mad up with spare wood. Then dug out that bucket I was going to use as a resovoir in the beginning of this journal. I previously blocked off the holes so was perfect for DWC. This was filled with nutes and bleach ready for transplant.
Sunday, I pulled as much out of my tent as I could and got my auto up potted so I could fit my benches in.

One side has thicker ply for drainage but both are slightly tilted to toe right. Both benches have 100w tube heaters underneath to hopefully add some heat to the tent. I still need to clean up my wires and get my resovoir prepped but it's in!

My clones weren't too happy. Last night when I checked on them this is how they looked

I think they was looking a bit better this morning but I could only poke my phone though the zipper as my 4x4 was still sleeping.

That's all I got for now but were I full force in a couple of days. Back to the grind for me

Clones have taken off mate
Nice job on grow room mods

 

[Greenvein]

Clones have taken off mate
Nice job on grow room mods

Cheers bro just waiting on my trays to arrive which I'll have to modify a bit but once in I think I'll call this my final set up no more fiddling. I plant on running just 4 plants in future too.. this is only to make up for lost time.

Here's the trays one each side.

I only have 1mx1m but they say it can be shortened then il use a heat gun to bring the sides in as I'm tight at 60cm.. I'm sure I can loose the other 6cm taking the angle off the sides

 

[Sparkey224]

Cheers bro just waiting on my trays to arrive which I'll have to modify a bit but once in I think I'll call this my final set up no more fiddling. I plant on running just 4 plants in future too.. this is only to make up for lost time.

Here's the trays one each side.

I only have 1mx1m but they say it can be shortened then il use a heat gun to bring the sides in as I'm tight at 60cm.. I'm sure I can loose the other 6cm taking the angle off the sides

Hell yeah bro, rock it out!

And a big congrats on NOTY contest homie! Looks like you're in the in 1st..I'm pulling for you, give them hell my friend

 

[Greenvein]

Hell yeah bro, rock it out!

And a big congrats on NOTY contest homie! Looks like you're in the in 1st..I'm pulling for you, give them hell my friend

Cheers brother! Much love. A long way to go yet. Pretty surreal my little nug done so well definitely proud of her whatever happens

 

[InTheShed]

Nice fishbones on the roots and I hope those tube heaters happy up the kids! How chilly is chilly?

 

[Greenvein]

Nice fishbones on the roots and I hope those tube heaters happy up the kids! How chilly is chilly?

Yeah roots and lady are looking good.. getting better with the temps up

Recently temps with lights on 21c so alot lower at night and lights off last couple of weeks temps outside have really dropped.

 

[InTheShed]

21º isn't too bad but below 18º you can start seeing deficiencies.

The effect of cold on cannabis plants

In this post we show you which methods you can use to avoid the cold in an indoor cannabis crop. There are various modes to keep a stable temperature during the winter so you can choose the resolution that best suits to your indoor or greenhouse crop for personal use.

www.alchimiaweb.com

 

[Greenvein]

21º isn't too bad but below 18º you can start seeing deficiencies.

The effect of cold on cannabis plants

In this post we show you which methods you can use to avoid the cold in an indoor cannabis crop. There are various modes to keep a stable temperature during the winter so you can choose the resolution that best suits to your indoor or greenhouse crop for personal use.

www.alchimiaweb.com

Yeah definitely below 18 at night..
We're looking better with temps up but as my room is small and my 4x4 in flower dehumidifier brings the humidity down. I'll see if I can get a humidifier in the tent tomorrow and get a happy balance. Clones should be on fire then I need a bigger room!

 

[Greenvein]

New trays and new nutes delivered today so pick them up after work and hopefully get into them straight away

Clones still looked a bit funny last night so might feed again with a bit more food. Didn't log the EC last feed so no clue what it was. Worst case I'll cause a day of droop.

Will continue using my old nutes in veg to finish them off but it's flower that always gets the issues week 3 so if same happens with the new nutes aswell then I'll stop using pure Coco and go back to mixed.. but if no issues I'll grab some new bags off pure Stick with Coco perlite.

 

[Absorber]

New trays and new nutes delivered today so pick them up after work and hopefully get into them straight away

Clones still looked a bit funny last night so might feed again with a bit more food. Didn't log the EC last feed so no clue what it was. Worst case I'll cause a day of droop.

Will continue using my old nutes in veg to finish them off but it's flower that always gets the issues week 3 so if same happens with the new nutes aswell then I'll stop using pure Coco and go back to mixed.. but if no issues I'll grab some new bags off pure Stick with Coco perlite.

Have you got yourself some CalMag?

 

[Greenvein]

Have you got yourself some CalMag?

Never been without it bro

 

[Greenvein]

Mars Hydro Giveaway grow
New light FC3000
Cheese Soulfire clones
Prepping
​

Quick update. Still working on temps as I'm still on the low side but hopefully pick up a draught excluder for my door tomorrow.
It's been a week since up pot and all roots have hit the bottom so planning on flipping in one week tops. Just need to get drip trays, drainage and feed pipes fitted.

Today I watered, removed labels and gave them new kiddy written name badges Will feed every few days untill irrigation is in to cheer them up.

Their doing ok lol had a rough life so far like being owned by Sid in toy story the DWC looks good. Need to check the water & roots then top up +bleach. Havent checked it for anything just left like the rest.

Will get there eventually. If the water is stil healthy tomorrow I'll star training the plant. Hopefully if she doesn't flower early I'll give her the 4x4 and put a small heater where she sits.

Thanks for your time

 

[InTheShed]

I'm just laughing at you treating them like Sid!

Are you thinking of cleaning off some of that lower growth on the potted ones to get them moving on top or are you going to leave it and hope it makes it to the top?

 

[Greenvein]

I'm just laughing at you treating them like Sid!

I'll have to let vegans know I really do hear a scream every time I undo the zipper that sounds kinda wrong

Are you thinking of cleaning off some of that lower growth on the potted ones to get them moving on top or are you going to leave it and hope it makes it to the top?

It's a good question that I was torn on. I will remove what's inside the pots as I will be putting misters in them to give a rain fall effect for better watering coverage but the rest should make the if I get a screen in soon

Lung buster and Miami madness both produced some dense and frosty flowers from nothing under the canopy so interested to see how it does if I left a few sites underneath.

Mind melters larf was ugly

Cheers bro

 

[Greenvein]

Mars Hydro Giveaway grow
New light FC3000
Cheese Soulfire clones
Prepping
​

Cheeky weekend update.. ladies have take off and theirs no stopping them now.. they need a net and flip asap! If I can get run off trays and drainage installed I will flip. Not sure how it will affect my Hydro auto but looks like she will be sticking around.
I was supposed to top up my DWC and bleach on Wednesday but forgot she looks happy but the bucket isn't chilled so hope the roots are ok.

Yesterday's zipper pic

Pics from today.. you can see I started running my piping for irrigation but I purchased a single manifold.. the T split will become a 90 bend with a 12 way splitter head on it so less space used up.

Happy weekend

 

[InTheShed]

They look heslthy AF GV!

 

[Absorber]

Mars Hydro Giveaway grow
New light FC3000
Cheese Soulfire clones
Prepping
​

Cheeky weekend update.. ladies have take off and theirs no stopping them now.. they need a net and flip asap! If I can get run off trays and drainage installed I will flip. Not sure how it will affect my Hydro auto but looks like she will be sticking around.
I was supposed to top up my DWC and bleach on Wednesday but forgot she looks happy but the bucket isn't chilled so hope the roots are ok.

Yesterday's zipper pic

Pics from today.. you can see I started running my piping for irrigation but I purchased a single manifold.. the T split will become a 90 bend with a 12 way splitter head on it so less space used up.

Happy weekend

Looking sweet mate
Can't wait to see the flower

 

[Sparkey224]

Looking great brother happy Sunday