- Thread starter
- #21
The Dirty
Well-Known Member
Hi all.
Plants are going great guns and I will hopefully hit my pb in this grow.
I was sifting through some stuff last night and came across the design of my room in regards to lighting and ventilation and thought I'd share.
So basically I have a 2&2 setup.
2 x 150mm cool tubes with 2 x 1500mm canfan rs series fans attached on the downwind side which then vent vertically out of the tent. I have insect screen on the open end of the cool tube to stop and insects or large particles making it onto the lights.
It's not the best for the fans to be on the downwind side as hot air will be passing through but I did some thinking and it just worked better for me this way.
As for intake I have a 150mm passive intake on the cold side of my tent and a 150mm active intake drawing air from another room which is permanently cool due to its location.
Anyways enough of that here is the raw design and feel free to ask q's or put fwd your 2 cents...
Plants are going great guns and I will hopefully hit my pb in this grow.
I was sifting through some stuff last night and came across the design of my room in regards to lighting and ventilation and thought I'd share.
So basically I have a 2&2 setup.
2 x 150mm cool tubes with 2 x 1500mm canfan rs series fans attached on the downwind side which then vent vertically out of the tent. I have insect screen on the open end of the cool tube to stop and insects or large particles making it onto the lights.
It's not the best for the fans to be on the downwind side as hot air will be passing through but I did some thinking and it just worked better for me this way.
As for intake I have a 150mm passive intake on the cold side of my tent and a 150mm active intake drawing air from another room which is permanently cool due to its location.
Anyways enough of that here is the raw design and feel free to ask q's or put fwd your 2 cents...