Hi all,
I need advice on what fan and filter setup I should use for my first growbox, a stealth one. The internal dimensions are 470w x 390d x 680h / 18" x 15" x 27" (see photos below).
My intention is to grow 2-3 plants in this (will it take it?) and use 2 x 42W CFLs per plant, so will have 6 sockets.
I've lined the box with panels made of card, silver-backed bubble wrap and Reflex Diamond Reflective Sheeting. It's location is a shed with a RH of around 60% and temp of 18C. I plan to introduce a thermostat and heater to raise the temp of the shed slightly, which will bring down the RH by a few points.
The exhast hole is 100mm diam while the intake is passive and 4x that. I was planning to buy a 100mm in-line fan and filter set (LTI Systemair RVK100 + matching CF160 filter.) This fan extracts 175m3/h. Both would be outside the box as shown below, both acting as a light trap (will that work?) and saving space inside.
box - duct - carbon filter - duct - in-line fan - duct - big wide world
My concern with this is will I be drawing out too much heat and have to heat the box more, which will both cost more and be visible via IR cameras. Is this a valid concern?
Can I make my own filters (are they as effective as the pro ones?) Either way, how effective are filters - if I decided to go down the PC fan route housed in the box and venting into the shed rather than the big wide world, would there be any smell at all? I am looking for zero smell.
Any advice would be gratefully received.
Regards
JA
I need advice on what fan and filter setup I should use for my first growbox, a stealth one. The internal dimensions are 470w x 390d x 680h / 18" x 15" x 27" (see photos below).
My intention is to grow 2-3 plants in this (will it take it?) and use 2 x 42W CFLs per plant, so will have 6 sockets.
I've lined the box with panels made of card, silver-backed bubble wrap and Reflex Diamond Reflective Sheeting. It's location is a shed with a RH of around 60% and temp of 18C. I plan to introduce a thermostat and heater to raise the temp of the shed slightly, which will bring down the RH by a few points.
The exhast hole is 100mm diam while the intake is passive and 4x that. I was planning to buy a 100mm in-line fan and filter set (LTI Systemair RVK100 + matching CF160 filter.) This fan extracts 175m3/h. Both would be outside the box as shown below, both acting as a light trap (will that work?) and saving space inside.
box - duct - carbon filter - duct - in-line fan - duct - big wide world
My concern with this is will I be drawing out too much heat and have to heat the box more, which will both cost more and be visible via IR cameras. Is this a valid concern?
Can I make my own filters (are they as effective as the pro ones?) Either way, how effective are filters - if I decided to go down the PC fan route housed in the box and venting into the shed rather than the big wide world, would there be any smell at all? I am looking for zero smell.
Any advice would be gratefully received.
Regards
JA