I built a closet in my home office this last week.. here's some before and after shots of the house. I've got a 400w hps/mh to hang in there, the ballast/fan/scrubber will be in an isolated area at the top of the closet. The only thing I haven't figured out yet is how to handle passive air intake space- I could easily have cut vents in the floor or outside walls- but then I'd have wildly varying intake temps throughout the year, so the intakes are going to have to come from inside the room. I'm thinking that I'll probably put some vent covers on the wall on both sides of the new door near the floor. You can see the size vent I'm planning on using in the last picture (I hope that two of those will provide enough intake space).
I'm either going to exhaust out a vent cap in the roof or directly into the eave of the house which will blow the exhaust into the walls and roof. Since I have a cool tube, I don't think temps are going to be a problem, I just have to change the air enough to keep co2 levels good. I have a 4" x 18" carbon scrubber and a 500cfm duct fan to work with.
I'll post some pics of the inside of the closet once the light/mylar/fan/etc are in later this week.
This closet will be home to a white widow scrog. Still have to design or find a small mother/clone cabinet somewhere.. not sure how I'm going to handle that yet.
I'm either going to exhaust out a vent cap in the roof or directly into the eave of the house which will blow the exhaust into the walls and roof. Since I have a cool tube, I don't think temps are going to be a problem, I just have to change the air enough to keep co2 levels good. I have a 4" x 18" carbon scrubber and a 500cfm duct fan to work with.
I'll post some pics of the inside of the closet once the light/mylar/fan/etc are in later this week.
This closet will be home to a white widow scrog. Still have to design or find a small mother/clone cabinet somewhere.. not sure how I'm going to handle that yet.