Rickstertp
Well-Known Member
So I have a 27x27x56 tent and have a light from niemiled that has one qb88 V2 board with a MEAN WELL LED Driver Single Output Switching Power Supply, 120 Watt 54V @ 2.3A A Model, 120 Watt - HLG-120H-54A driver. The driver has two pots under rubber plugs that can be adjusted. One Voltage and the other labeled "I" which I assume is current adjust. I am doing two plants at the moment, but might stick to one at a time for the future. So questions:
1. Should I run my light at full V&I or should these be turned down a bit? I had seen some comments about not running LED at full power but don't know if it applies to these lights.
2. If I should or wish to adjust the light output, do I adjust the voltage or current?
3. What do you recommend for the height above the canopy for this light?
Thank you!
1. Should I run my light at full V&I or should these be turned down a bit? I had seen some comments about not running LED at full power but don't know if it applies to these lights.
2. If I should or wish to adjust the light output, do I adjust the voltage or current?
3. What do you recommend for the height above the canopy for this light?
Thank you!