saulgoodman18
420 Member
Hi Guys,
I have a 600w HID light with a ballast that has controls with the ability to reduce down to 250w. The area I am growing in is around 1 meter by 1 meter.
The problem I am facing is maintaining desired temperatures (20c-25c). I can only achieve such temps once I Reduce the lights potency to 250w. The next setting up is 400w which takes the room temperature to around (30c-35c) 10c over desired. This is with intake and outtake fans on max, during these warmer months the fans just cannot achieve the temperatures while at 400w the heat output is just too high. I am desperately trying to figure out the best route to take while my seed's germinate. My question is 250w to low or is it fine or is it just not enough? Alternatively I have been looking into LED lights more specifically the Mars II which should produce much less heat.
Any advise is greatly appreciated!
I have a 600w HID light with a ballast that has controls with the ability to reduce down to 250w. The area I am growing in is around 1 meter by 1 meter.
The problem I am facing is maintaining desired temperatures (20c-25c). I can only achieve such temps once I Reduce the lights potency to 250w. The next setting up is 400w which takes the room temperature to around (30c-35c) 10c over desired. This is with intake and outtake fans on max, during these warmer months the fans just cannot achieve the temperatures while at 400w the heat output is just too high. I am desperately trying to figure out the best route to take while my seed's germinate. My question is 250w to low or is it fine or is it just not enough? Alternatively I have been looking into LED lights more specifically the Mars II which should produce much less heat.
Any advise is greatly appreciated!