reeferstick

New Member
Hi,

Been growin now for a few years and never had any major problems. i use my same setup recently cleaned with freshwater, and use my same nutrient ratio's ive always used. however yesterday i noticed my plant starting to droop, its almost as if the leaves are to heavy for it, normally all my growth would be reaching for the sky but its all dangling in the hydroton. . . also one plant is showing spots. . . again ive never had any issues like this. . . if my plants dont grow i dont pay the rent

flowering setup
600w hps
3x3 flood tray w/hydroton pellets
15 gallon res
general hydroponics 5 part
plenty of air circulation
temps 80 degrees around 70 at low
watering when the light comes on, and then two more time before it goes off.
i did use some physan 20 cleaning the hydroton. but it was recommended from the hydrostore and labeled safe for plants.
 
Well my man according to my charts here...it's looking like a cal/mag prob since they aren't flowerin yet....Also look like alittle iron too.. Your cal/mag aditive will have all the added trace irons and sulfers you also need...Are our pH 's looking normal?....
 
ph is fine, i use gh liquid tester. im in the right colors.
i am also in flowering half way into second week. i always flower 2 weeks after clones are taken.
 
Back
Top Bottom