gangadoctor
New Member
as with all newbies i used to overfeed my plants and after sometime (and the help of this forum) i discovered that i could feed less BUT recently i've been keeping my A & B to a minimum and am now wondering how that affects overall bud size.
for example, in bloom, after a flush in a 150 litre recirculating DWC i'm feed my plants 100ml big bud, 100ml explode, 75ml bud factor x, 20ml calmag plus, 10 ml silicon, and 100ml A & B. the leaves are a little light for my liking but the girls look nice and healthy.
about 5 days or o later the ppm's drop as they feed and to keep my ppm's low i'll normally feed A & B at say 30ml and the other nutes listed above at the same strengths. then when i hot the 2 week mark i flush and start again.
i'm wondering if i'm using enough A & B in the ratio and if that is affecting my bud size? i've been doing it this way o long that i don't really know any different.
for example, in bloom, after a flush in a 150 litre recirculating DWC i'm feed my plants 100ml big bud, 100ml explode, 75ml bud factor x, 20ml calmag plus, 10 ml silicon, and 100ml A & B. the leaves are a little light for my liking but the girls look nice and healthy.
about 5 days or o later the ppm's drop as they feed and to keep my ppm's low i'll normally feed A & B at say 30ml and the other nutes listed above at the same strengths. then when i hot the 2 week mark i flush and start again.
i'm wondering if i'm using enough A & B in the ratio and if that is affecting my bud size? i've been doing it this way o long that i don't really know any different.