--------------------------------------------------------------------------------------------------------------------------
Here is the list of preparing.
1. Dispensing Needle 1"
2.Syringe, 30mL or bigger
Caution: make sure your needle match with your syringe.3.Needle-nose pliers
4.power drill
5.1/4 and 1/16 drill bits
6.hot glue gun
7.Plastic Tubing, Clear, 1/8" ID x 1/4" OD
--------------------------------------------------------------------------------------------------------------------------
First, remove the head of the dispensing needle, and make sure that remove all the needle part.
Second, use 1/16 drill bit to drill a hole on the dispensing needle.
Third, use 1/4 drill bit to drill on cap of bottle, put the plastic tubing in the hole and make sure the length reach to the bottom of bottle. Use the glue gun to stabilize and seal the gap
Forth, after drying the glue, connect the needle part with tubing, and use glue gun to seal and stabilize.
then, finish!!!!!!!
Hope you like my way very much.
