mk2SMOKEY
Well-Known Member
Hello everyone,i'm back again to attempt another run of autos.
What we will be using this time around-
Seeds:
Mephisto Genetics,
1xToothless Alien
1xForgotten Strawberries
1x#12(Samsquanch x Forum Stomper)
Light:
HLG Blackbird
Tent:
3x3 Gorilla grow tent
Intake:
Ac infinty T4 with filter
Exhaust:
Ac infinity T6 with filter
Nutrients:
Advanced Nutrients
Connoisseur Coco Grow A+B
Connoisseur Coco Bloom A+B
Sensi Coco Bloom A+B
CalMag extra
B52
Voodoo juice
Bud candy
Big bud Coco
Overdrive
Flawless finish
Bits and pieces:
Small dehumidifier
Large dehumidifier
Small humidifier
Large AirCon
Ac infinity S6 tent clip fan
Tower fan
3x3Gallon fabric pots
Multiple little fans if needed
Muliple Hygro/temp meters
PH down
PH and PPM meter
Coco disc plug
Coco brick
Perlite
Braided hose
3x 6inch water rings
Fixings,ball valves and submerge' pump.
Right then,now thats all the bits and bobs out the way we will begin.
I brought a 75L Coco brick,a bag of small pieces perlite and some small Coco discs.
Soaked seeds in tap water for 24H,as they was soaking i prepared my Coco.
I just cut Coco brick in half and added a extra small corner into a large tub,added quite a few liters of boiling water to the tub and waited,after 15mins i started to mix it up and it became the normal constistancy.
This tub was left in front of a heater for 24H.
The top brick is yet to be soaked and mixed but together there will be around 40L here:
Seeds have been soaking for 24H now so they are ready for there little Coco disc,I made a mix of 1L Tap water and 2ml CalMag,PH to 5.8 then drop the discs inside.
1minute later and they are ready,not dripping with water but nice and moist bottom and dampish on top.
Poke a little hole maybe 5ml deep,placed the seeds inside and lightly covered with Coco.
These were then placed into a small propagation tray,lightly misted with the mixture i already made earlyier,put on a small heat mat,lid placed on and covered with a towel.
24H later and 1 or 2 are ready to pop above ground.
48H after putting them in there discs they are all above ground.
This will be Day 1:
Day2:
I stuck a small Led inside the tub they are in.
I made a mix of -
1L water
2ml CalMag
PH5.8
and put around 100-200ml of this into the base of the propagation tub,covered with lid and just left.
Day3:
I setup the tent and place all the things needed inside.
First time using this light so it will be a struggle to get right.
I hung the light 63in' from the floor.
After doing that i started to give my perlite a clean before use,i just used boiling water and a sieve,leave to dry for a cheeky half hour.
While the perlite was drying i got my pots,saucers,stands and Coco ready to mix.
I mixed together and hopefuly got a constistancy of 25% perlite to Coco,i put a nice thin layer of perlite at the bottom of pots and started to fill with the Coco/perlite mix.
Made a nice size hole in the middle of pots and placed the seedlings inside,covered and lightly pressed down.
After checking the PH of the 800ml feed mix left from yesterday,i poured this mix about 1inch around the base of each seedling.
These were then placed inside the tent and everything turned on.
Light is on its first click(the lowest it can go) and around 48in' away from there tops.
Temps:
Day:24-25c and 75-80% Humidity
Night-20-21c and 73-75% Humidity
Day4:
I can see the small growth coming through so all is well.
Made a mix of:
1L Water
2ml CalMag
0.75 Each Grow A+B
0.5ml Voodoo Juice
PH5.8
They recieved around 330ml each and all having it in a circle about 1inch around the stem.
Thank you for stopping bye.
What we will be using this time around-
Seeds:
Mephisto Genetics,
1xToothless Alien
1xForgotten Strawberries
1x#12(Samsquanch x Forum Stomper)
Light:
HLG Blackbird
Tent:
3x3 Gorilla grow tent
Intake:
Ac infinty T4 with filter
Exhaust:
Ac infinity T6 with filter
Nutrients:
Advanced Nutrients
Connoisseur Coco Grow A+B
Connoisseur Coco Bloom A+B
Sensi Coco Bloom A+B
CalMag extra
B52
Voodoo juice
Bud candy
Big bud Coco
Overdrive
Flawless finish
Bits and pieces:
Small dehumidifier
Large dehumidifier
Small humidifier
Large AirCon
Ac infinity S6 tent clip fan
Tower fan
3x3Gallon fabric pots
Multiple little fans if needed
Muliple Hygro/temp meters
PH down
PH and PPM meter
Coco disc plug
Coco brick
Perlite
Braided hose
3x 6inch water rings
Fixings,ball valves and submerge' pump.
Right then,now thats all the bits and bobs out the way we will begin.
I brought a 75L Coco brick,a bag of small pieces perlite and some small Coco discs.
Soaked seeds in tap water for 24H,as they was soaking i prepared my Coco.
I just cut Coco brick in half and added a extra small corner into a large tub,added quite a few liters of boiling water to the tub and waited,after 15mins i started to mix it up and it became the normal constistancy.
This tub was left in front of a heater for 24H.
The top brick is yet to be soaked and mixed but together there will be around 40L here:
Seeds have been soaking for 24H now so they are ready for there little Coco disc,I made a mix of 1L Tap water and 2ml CalMag,PH to 5.8 then drop the discs inside.
1minute later and they are ready,not dripping with water but nice and moist bottom and dampish on top.
Poke a little hole maybe 5ml deep,placed the seeds inside and lightly covered with Coco.
These were then placed into a small propagation tray,lightly misted with the mixture i already made earlyier,put on a small heat mat,lid placed on and covered with a towel.
24H later and 1 or 2 are ready to pop above ground.
48H after putting them in there discs they are all above ground.
This will be Day 1:
Day2:
I stuck a small Led inside the tub they are in.
I made a mix of -
1L water
2ml CalMag
PH5.8
and put around 100-200ml of this into the base of the propagation tub,covered with lid and just left.
Day3:
I setup the tent and place all the things needed inside.
First time using this light so it will be a struggle to get right.
I hung the light 63in' from the floor.
After doing that i started to give my perlite a clean before use,i just used boiling water and a sieve,leave to dry for a cheeky half hour.
While the perlite was drying i got my pots,saucers,stands and Coco ready to mix.
I mixed together and hopefuly got a constistancy of 25% perlite to Coco,i put a nice thin layer of perlite at the bottom of pots and started to fill with the Coco/perlite mix.
Made a nice size hole in the middle of pots and placed the seedlings inside,covered and lightly pressed down.
After checking the PH of the 800ml feed mix left from yesterday,i poured this mix about 1inch around the base of each seedling.
These were then placed inside the tent and everything turned on.
Light is on its first click(the lowest it can go) and around 48in' away from there tops.
Temps:
Day:24-25c and 75-80% Humidity
Night-20-21c and 73-75% Humidity
Day4:
I can see the small growth coming through so all is well.
Made a mix of:
1L Water
2ml CalMag
0.75 Each Grow A+B
0.5ml Voodoo Juice
PH5.8
They recieved around 330ml each and all having it in a circle about 1inch around the stem.
Thank you for stopping bye.