Cannabis Curing Guide using a Hygrometer

Cannabis Curing Guide using a Hygrometer

Step 1: The Dry
-Harvest and Hang
-3 to 14 days depending on relative humidity and temperature
-Keep it dark

Step 2: The Feel
-Buds start to “feel” dry
-Stems “feel” dry but are flexible and don’t snap when bent
-Time to jar the buds

Step 3: The Jar (65% - 70%)
-RH should be 70% at maximum
-The key in this phase is to get the RH down to 65% relatively
fast to prevent mold
-If hygrometer readings rise 1% an hour, this
indicates a high RH in the jar
-If RH is greater than 70% you need to leave the
lid off for 1 to 4 hours or even remove
from the jar if necessary depending on the RH
and temperature in the room
-Burp the jars for 1 to 2 hours per day to reach 65% RH
-It may take 24 hours to get a stable RH reading

Step 4: The Cure (60% - 65%)
-Looking for a much slower release of moisture.
-Burp jars for a very short period once a day
-Stable RH readings may take up to 36 hours

Step 5: The Smoke (60% to 55%)
-The cure continues
-It's ready to smoke
-Burp once a day until desired smoking RH is reached
-can be stored for longer periods up to 3 months
-Curing (65% to 55%) should take a minimum of 2 weeks
-Can cure as long as 1 to 6+ months

Step 6: The End
-The cure stops at 55%
-Ready for long term storage up to 3+ months/years?
-Can rehydrate to reach preferred smoking RH
-Rehydrating will not restart the cure process

Comments

Temperature:

Experts have learned that the ideal level of temperature is from 18.3 to 23.8 degrees Celsius
(65 °F to 75 °F). When temperature is below the minimum 18.3 degrees (65 degrees Fahrenheit), the drying process will go very slowly. Going over the advised 23.8 degrees (75 degrees Fahrenheit) will indeed dry the buds faster and may cause a poor taste. Just keep the temperature within the optimum range and your weeds will be fine.

Humidity:

Humidity should be from 45% to 55%.
 
Last edited:

Blog entry information

Author
Scarfinger68
Read time
2 min read
Views
81
Comments
1
Last update

More entries in Member Blogs

More entries from Scarfinger68

Back
Top Bottom