Blog entries by InTheShed

Building Scrog nets. Requires 3/4” cpvc 4 T’s and 4 90’s cut your cpvc to 10” lengths and assemble as follows. Then drill holes every 2” all the way around and finish by running string through it and weaving the final pattern. Then use tomato spikes to secure the Scrog frame to the plant...

Apologies in advance if this gets a bit wordy, and if I'm stating something obvious that everyone knows, it's just because it's news to me! I'm doing a bit of research as a result of reading a link in a post by Lucifer86 on what's in reclaim. I was taken by this paragraph: I have read...

From what I've learned, topical oils should be at least 10mg THC/ml oil. Higher is good too, but lower is obv less or ineffective for pain and probably for anything you would use canna oil for. If your cannabis is decarbed, great. If not it needs to be 80 to 100% decarbed before you make...

Don't make it complicated with mount-on and high power loupes and one for looking and one for pics! Here is how I do it with a $10 8x loupe and a 5 year old Samsung S4 And get results like this: Sorted!

Now that my salve/cream/ointment/balm is done, I thought I'd post the whole process summarized on the blog: • 51 grams decarbed bud (cleaned of botrytis per this method), roughly 10% THC per the breeder • 12 ounces fractionated coconut oil • 4 hours on low in a small crock pot, 8 hours cooling...

First off, my hygrometer reads higher than the actual RH based on the salt slurry test. Therefore, all photos of the meter are off (no calibration option). All percentages in the following have been adjusted accordingly. Let me start by talking about the success of Scientific's oven-dried...

Let me start by saying that steaming wet dope smells DISGUSTING! My family had to leave the house it smelled so bad. Like boiled brussels sprouts but worse. I do not recommend it unless absolutely necessary! So to review, the plan was to waste none of the plant, including the buds with...